Integration of soft tooling by additive manufacturing in polymer profile extrusion process chain

Integrating additive manufacturing (AM) into polymer extrusion offers process chain flexibility and design freedom. It reduces the need for time-consuming iterations and trial-and-error in the die design process. Consequently, polymer AM of extrusion (i.e., soft tooling) allows for a shorter product development cycle and cost-effectiveness for small-scale production and highly customized products. In this study, carbon fibre (CF)-polyether-ether-ketone (PEEK) dies were manufactured using the fused filament fabrication (FFF) AM process, employing a streamlined die design achieved through freeform transition planes. Calibration slides were produced using masked stereolithography (MSLA), FFF, and conventional manufacturing techniques (i.e., machining) to preserve the final product’s cross-section during the cooling process. The dimensional and surface characteristics of these calibration slides were evaluated to assess the dimensional accuracy and surface topography of various materials and manufacturing processes. The dimensional evaluation reveals that MSLA-printed parts exhibit deviation from the nominal dimension closer to the conventionally manufactured part. The integrated soft tooling in the polymer extrusion line was tested with polypropylene (PP) and acrylonitrile butadiene styrene (ABS) as extruded materials. The surface topography of the CF-PEEK die displays distinctive ripple features resulting from the FFF process, identified by relatively flat peaks and deep valleys. The overall surface texture parameter values of CF-PEEK were higher due to the presence of deep valleys. Considering that the areas around the peaks interacted more with polymer molecules during the extrusion, the surface texture parameters of the extrudates were closer to the value observed in 90 µm region areas around the peaks. Notably, extrudates of AM calibration slides have lower surface texture parameters than extrudates of conventionally manufactured calibration slides, even though surface defects in the form of dimple sink marks were observed in extruded material of PP from extrudates using AM calibration slides.