The behaviour of foaming molten PVC flowing out of capillaries was studied. Compositions of granulated PVC plasticate with 0 to 2% blowing agent (Genitron EPA) were extruded on a Plastograph Brabender through dies 3 mm in diameter and various lengths at temperatures of 160, 170 and 180°C. The variations of the stream profile of the flowing melt and of the diameter of the extrudate after cooling were examined. It was found that the extrudate swell was largest for a 1% concentration of the blowing agent and at a distance from the capillary outlet which increased with increasing capillary length and flow rate. The influence of the blowing agent on the total extrudate swell was determined by the kinetics of formation and development of the gas phase in the flowing melt and was the result of a decrease in the density and creation of a definite type of foam structure in the extrudate.