材料科学
圆角(机械)
桁架
压力传感器
灵敏度(控制系统)
熔融沉积模型
涂层
复合材料
3D打印
有限元法
光电子学
机械工程
结构工程
电子工程
工程类
作者
Huan Zhao,Julia E. Huddy,William J. Scheideler,Yan Li
标识
DOI:10.1002/adem.202301056
摘要
Metastructure‐based pressure sensors (MBPS) offer higher sensitivity, broader sensing range, greater design flexibility, and superior performance tunability compared with traditional pressure sensors. Currently, there exists a gap between metastructure architecture design and prediction of sensing performance. To this end, a new design‐to‐manufacturing paradigm is presented. A coupled mechanical‐electrical finite element model is developed to predict sensing performance of systematically designed MBPS. Rapid prototyping by additive manufacturing is achieved via micro‐digital light processing and atomic layer deposition for forming nanoscale conductive coatings. Results indicate that a large sensing range requires high metastructure stiffness, achieved by increasing relative density. However, high sensitivity and reversible sensing both rely on elastic coating deformation—enforcing a balance between these properties. The trade‐off between sensing range and sensitivity is investigated for structures with different Poisson's ratios and fillet ratios. Metastructure architecture design can lead to substantial expansion of the sensing range, enabling pressure detection ranging from 0 to 15 MPa (6.23% strain). An impressive sensitivity variance of 6.8 times has been observed between the highest and lowest MBPS samples. Finally, it is demonstrated how the design framework allows deep electromechanical integration of 3D‐printed sensors with additively manufactured components, such as a truss bridge.
科研通智能强力驱动
Strongly Powered by AbleSci AI