材料科学
润滑油
摩擦学
石墨烯
基础油
复合材料
氧化物
碳纤维
扫描电子显微镜
纳米结构
纳米技术
冶金
复合数
作者
M. Shilov,А. И. Смирнова,L. N. Zhukova,A. A. Gvozdev,N. N. Rozhkova,T. P. Dyachkova,N. V. Usol’tseva
标识
DOI:10.3103/s1068366623030091
摘要
The following carbon nanostructures (CNSs) are used: shungite nanocarbon (Sh), multilayered graphene oxide (GO), multiwalled carbon nanotubes (Taunit-M), and fullerene C60. Medical Vaseline (MV) free from any additives or thickeners is used as a lubricant base. Tribological tests are carried out using a 2070 SMT-1 friction machine at a load of 2000 N. The roughness parameters of steel rollers before and after the tests are studied by profilometry. Detailed characteristics of contacting surfaces before and after friction are obtained by scanning and transmission electron microscopy. The experimental data are analyzed using the Hertz and Johnson–Kendall–Roberts models. According to the data on efficiency coefficients kef, the studied dispersions are ranked as follows in the order of deterioration of antiwear properties: MV/GO (0.5 wt %), kef of 50% > MV/Taunit-M (1.5 wt %), kef of 40% > MV/C60 (0.5 wt %), kef of 15% > MV/Sh (0.5 wt %), kef of 5%, which is in agreement with the above-mentioned sequence of CNSs at low loads. The reason for the best and worst wear factors upon using CNSs in the dispersions under study and factors affecting the values of wear in the hard friction mode are considered. The results of the study can be a basis for the development of new plastic lubricating compositions with carbon nanostructure additives for use in heavily loaded friction units.
科研通智能强力驱动
Strongly Powered by AbleSci AI