薄脆饼
材料科学
直接结合
绝缘体上的硅
光电子学
表面粗糙度
扫描电子显微镜
硅
光致发光
激光器
波导管
蚀刻(微加工)
晶片键合
基质(水族馆)
光学
纳米技术
复合材料
图层(电子)
地质学
物理
海洋学
作者
Takehiko Kikuchi,Munetaka Kurokawa,Naoki Fujiwara,Naoko Inoue,Takuo Hiratani,Toshiyuki Nitta,Takuya Mitarai,Yuhki Itoh,Chang‐Yong Lee,Akira Furuya,Yoshitaka Oiso,Nobuhiko Nishiyama,Hideki Yagi
标识
DOI:10.35848/1347-4065/acfcf9
摘要
Abstract The direct bonding process of InP chips on a silicon-on-insulator (SOI) wafer is investigated using surface hydrophilization by UV-ozone treatment. The influence of the treatment on surface roughness is observed by atomic force microscopy, and found to be negligibly small. A high-quality III–V/Si bonding interface without crystal defects is verified in a scanning transmission electron microscope observation. The III–V layers remaining on the SOI wafer after the removal process of the InP substrate show uniform photoluminescence intensity over the whole region of the chip, indicating a bonding interface without the influence of lateral etching and peeling-off. From this bonding process, Fabry–Perot lasers with III–V gain and Si waveguide regions are fabricated, and cw operation is successfully achieved at a stage temperature from 20 °C to 85 °C. Stable operation is also confirmed from the changes of threshold current in the aging test (200 mA at 85 °C) after 2000 h.
科研通智能强力驱动
Strongly Powered by AbleSci AI