纳米线
响应度
兴奋剂
铟
紫外线
材料科学
氧化铟锡
光电效应
光电子学
纳米技术
带隙
纳米棒
氧化锡
氧化物
紫外线
可见光谱
红外线的
宽禁带半导体
锡
作者
Junjun Xue,Jiyuan Huang,Kehan Li,Ping Liu,Yan Gu,Ting Zhi,Yan Dong,Jin Wang
标识
DOI:10.1088/1674-4926/25020024
摘要
Abstract Low power consumption, high responsivity, and self-powering are key objectives for photoelectrochemical ultraviolet detectors. In this research, In-doped α-Ga2O3 nanowire arrays were fabricated on fluorine-doped tin oxide (FTO) substrates through a hydrothermal approach, with subsequent thermal annealing. These arrays were then used as photoanodes to construct a ultraviolet (UV) photodetector. In doping reduced the bandgap of α-Ga2O3, enhancing its absorption of UV light. Consequently, the In-doped α-Ga2O3 nanowire arrays exhibited excellent light detection performance. When irradiated by 255 nm deep ultraviolet light, they obtained a responsivity of 38.85 mA/W. Moreover, the detector's response and recovery times are 13 and 8 ms, respectively. The In-doped α-Ga2O3 nanowire arrays exhibit a responsivity that is about three-fold higher than the undoped one. Due to its superior responsivity, the In-doped device was used to develop a photoelectric imaging system. This study demonstrates that doping α-Ga2O3 nanowire with indium is a potent approach for optimizing their photoelectrochemical performance, which also has significant potential for optoelectronic applications.
科研通智能强力驱动
Strongly Powered by AbleSci AI