材料科学
退火(玻璃)
接触电阻
肖特基势垒
金属
薄脆饼
蚀刻(微加工)
电阻率和电导率
分析化学(期刊)
光电子学
复合材料
冶金
图层(电子)
电气工程
工程类
化学
二极管
色谱法
作者
Liancheng Wang,Zhiqiang Liu,Enqing Guo,Hua Yang,Xiaoyan Yi,Guohong Wang
摘要
The electrical characteristics of metallization contacts to flat (F-sample, without wet-etching roughed) and wet-etching roughed (R-sample) N-polar (Nitrogen-polar) n-GaN have been investigated. R-sample shows higher contact resistance (Rc) to Al/Ti/Au (~2.5 × 10(-5) Ω·cm(2)) and higher Schottky barriers height (SBH, ~0.386 eV) to Ni/Au, compared with that of F-sample (~1.3 × 10(-6) Ω·cm(2), ~0.154 eV). Reasons accounting for this discrepancy has been detail investigated and discussed: for R-sample, wet-etching process caused surface state and spontaneous polarization variation will degraded its electrical characteristics. Metal on R-sample shows smoother morphology, however, the effect of metal deposition state on electrical characteristics is negligible. Metallization contact area for both samples has also been further considered. Electrical characteristics of metallization contact to both samples show degradation upon annealing. The VLED chip (1 mm × 1 mm), which was fabricated on the basis of a hybrid scheme, coupling the advantage of F- and R-sample, shows the lowest forward voltage (2.75 V@350 mA) and the highest light output power.
科研通智能强力驱动
Strongly Powered by AbleSci AI