乙二胺四乙酸
浸出(土壤学)
电解质
化学
石墨
电化学
螯合作用
X射线光电子能谱
无机化学
杂质
碱性电池
电极
介电谱
化学工程
表面改性
硫酸
溶解
化学状态
碳酸盐
材料科学
冶金
核化学
活性炭
重新使用
电解
环境化学
作者
Y. J. Cho,S. H. Lee,Seunga Yang,Soon‐Ki Jeong
摘要
The electrochemical reuse of spent graphite from the negative electrodes of lithium-ion batteries is influenced by regeneration-induced changes in near-surface chemical and defect states. These states govern solid electrolyte interphase (SEI) re-formation, particularly when bulk contaminants are suppressed. Acidic malic-acid leaching and ethylenediaminetetraacetic acid chelation under alkaline conditions (pH 8.7) were compared under similar operating parameters to isolate the role of the leaching environment. This was followed by heat treatment at 1200 °C to decouple chemical cleaning from structural restoration. Both methods reduced the total impurities from 217.85 ppm to ~1.8 ppm, approaching that of commercial graphite. Despite the comparable bulk purity, depth-resolved X-ray photoelectron spectroscopy after formation cycling revealed distinct outermost surface states relevant to SEI re-formation: acidic processing yielded a more oxygenated carbon signature and higher LiOH fraction at the outermost surface (~16%), whereas alkaline chelation produced a more graphitic, carbonate-dominated surface with lower LiOH (~7%). Electrochemical and impedance measurements were consistent with these differences, suggesting that after the bulk impurities were minimized, resistance development was largely governed by the leaching-conditioned near-surface state, which biased the SEI composition. The comparison under matched conditions linked the regeneration environment to SEI-relevant surface speciation and provided a mechanistic basis for selecting regeneration routes to reuse spent graphite as a negative-electrode active material.
科研通智能强力驱动
Strongly Powered by AbleSci AI