摘要
Introduction: Cisplatin (Cisp) causes excessive Ca2+ and Zn2+ influxes mediated by TRPV1 channel stimulation and produces a high concentration of mitochondrial (mROS) and cytosolic (cROS) free reactive oxygen radicals. In clinical trials, it can be used in combi-nation with other adjuvant medicinal agents to enhance the safety and efficacy of Cisp. Alt-hough contradictory findings exist, eicosapentaenoic acid (EPA) as an adjuvant has been shown to suppress the proliferation of ovarian cancer cells. We assessed the effects of EPA and Cisp incubations on oxidant levels, Zn2+, lysosomal injury, and apoptotic markers in the OVCAR-3 ovarian cancer cell line by activating TRPV1. materials and methods: 2.1. Cell culture The OVCAR-3 ovarian cancer epithelial cell line from the American Type Culture Collection (ATCC) was used in this study. OVCAR-3 cells were cultured in 5 ml RPMI cell culture media in the identical the amount. In addition, the medium also includes one percent penicillin-streptomycin combination and ten percent fetal bovine serum (Gibco Inc., Istanbul, Türkiye). The connected cells were investigated using a laser confocal microscope (LSM-800) (Carl Zeiss, Oberkochen, Germany) in glass bottom dishes (35 mm) from Mattek Corporation Inc., Ashland, MA, USA. For the remaining analyses, the 2x106 cells were seeded in T25 cm2 flasks with filter lids. 2.2. Study groups Five groups of OVCAR-3 cells were generated: (1) the control group (Ctrl), which was maintained in cell culture conditions for 24h; (2) the EPA group, which was exposed to 100 M of EPA (Cat #: NC9892897, Cayman Chemical) for 24h [12]; (3) the Cisp group, which was exposed to 25 M Cisp for 24h [6, 12]; and (4) the Cisp plus EPA group, which was exposed to both of them. In the fifth group, TRPV1 antagonist (CPZ) was added and the cells were cultured for an additional hour [24, 25]. 2.3. The analyses of cell proliferation, debris, and viability The MTT test was used to analyze the cell viability, however the CASY TT counting cell equipment (Roche, Mannheim, Germany) was used to count the number of cells and debris (waste of dying cells) [26, 27]. After being suspended in 10 milliliters of the diluting solution, the OVCAR-3 cells were examined in accordance with the instructions of manufacturer. The CASY method combines resistance detection for particle detection with pulse region assessment based on electronic pulse process methodology [28]. Therefore, it is possible to distinguish between living and dead cells. Cell viability results were shown as percentage changes, and cell and debris counts were expressed as x107 per milliliter and x106 per milliliter, respectively. 2.4. Evaluation of the concentration of cytoplasmic free Ca2+ concentration ([Ca2+]c) Following the incubation of the cells in the Fluo-3/AM (Cell Signaling Technology) solution, the cells adhering in the dishes were washed and then given 1 ml of extracellular buffer. The green images of Fluo-3/AM were acquired for the LSM-800 confocal microscopy analysis, and the diode laser stimulation was kept at 488 nm. Following the application of the TRPV1 stimulator (10 µM CAP), the OVCAR-3 cells were subjected to the TRPV1 antagonist (100 µM CPZ) in order to inhibit Ca2+ entrance. For the mean Fluo-3/AM fluorescence intensity, the results were expressed as a.u. 2.5. Electrophysiology Conventional whole-cell patch-clamp electrophysiological measurements were conducted with a patch-clamp set at room temperature (23 ± 2 °C) and an EPC 10 amplifier (HEKA, Lamprecht, Germany) [10]. The electrode cell resistances obtained from a puller (PC-10, Narishige, Tokyo, Japan) utilized for whole cell recording ranged from 4 to 6 MΩ. Previous research detailed the components of intracellular and extracellular buffers [24, 29]. In order to produce an extracellular solution devoid of Na+, we introduced 150 mM N-methyl-D-glucamine (NMDG+) and used HCl to correct the pH. The voltage of the cells was capped at -60 millivolts. An external TRPV1 antagonist (100 M CPZ) was used in the study to reduce the TRPV1 currents that extracellular 10 M CAP generated in cells. The results of the TRPV1 current were displayed as pA/pF. 2.6. The CSP/3, CSP/8, CSP/9, and apoptosis assays Cellular apoptosis level was measured in accordance with the manufacturer's instructions using an APOPercentage detection kit (Biocolor Ltd., Co Belfast, UK) in a plate reader (Infinite PRO 200; Tecan Austria GmbH, Groedig, Austria) analysis (at 550 nm). As previously reported, caspase substrates were used in the plate reader (Infinite PRO 200) to evaluate the activities of CSP/3, CSP/8, and CSP/9 [24, 29]. In the Infinite PRO 200, the caspase substrate cleavages were examined between 380 and 460. Fluorescence units per milligram of protein were computed in the cells following the Biuret method's determination of protein levels. The outcomes of CSP/3, CSP/8, CSP/9, and apoptosis were shown as percentage increases over the level observed prior to treatment. 2.7. mROS and cROS detections While the production of mROS (ThermoFischer Scientific, Istanbul, Türkiye) was carried out using the MitoSOX Red reagent (Cat #: M7513), the production of cROS was detected using 2,7-dichlorofluorescein diacetate (DCFH-DA, Cat #: C6827). Grown in 35-mm dishes, OVCAR-3 cells were loaded for 15–20 minutes at 37°C with 20 mM DCFH-DA and MitoSOX Red. Using an LSM-800 confocal microscope, cell fluorescence variations of MitoSOX and DCFH-DA as an arbitrary unit (a.u.) were examined immediately after two washes of ice-cold 1xPBS washing. The diode laser stimulation in the MitoSOX was maintained at 561 nm, although DCFH-DA was adjusted to 488 nm to stimulate the OVCAR-3 cells [29]. 2.8. Detections of mitochondrial membrane potential (mMP) The Mito Probe JC-1 (Cat #: T3168, ThermoFischer Scientific) dye was used to detect the changes in mMP. The OVCAR-3 cells in the dishes from treatment groups and controls were incubated in cell culture medium with 10 uM JC-1 for 15-20 min in the dark. Then, the cells were washed twice by staining extracellular buffer and analyzed by LSM-800 confocal microscope for 1 h. The red aggregation showed normal mMP, while the green monomer indicated a reduction in mMP due to mitochondrial dysfunction. Results were presented as the rate of red aggregation/green monomer stained by JC-1. 2.9. Cell death percentage Ten μM Hoechst 33342 and 20 μM propidium iodide were added to the cell medium in the dishes. Propidium iodide (PI), which only stains chromatin DNA in dead cells and fluoresces red, can be used to determine the percentage of dead cells (PI-positive cells). Hoechst is a blue fluorescent dye that stains chromatin DNA. Using a 40x oil objective, images were captured with the LSM confocal microscope and processed with Blue ZEN software. PI was turned on at 561 nm and Hoechst 33342 at 405 nm using a diode laser. In total, 25–50 cells were counted across distinct fields (n = 5–8). At least three separate inductions were used in each experiment. It was calculated to find the percentage of cell death (PI) relative to living cells. 2.10. Reduced glutathione (GSH) imaging analysis To determine the GSH concentrations in OVCAR-3 cells, the ThiolTracker Violet GSH measuring assay (Cat #: T10095, ThermoFisher Scientific) was used. ThiolTracker Violet green images in the OVCAR-3 were captured using the ZEN software (blue edition 3.2) and an LSM confocal microscope equipped with a 40x1.3 DICIII oil objective (Ext: 526 nm, Emi: 405 nm) [30] The fluorescence intensity differences of green color images were expressed as a.u. 2.11. Analysis of cytosolic (cZn2+) and mitochondrial (mZn2+) Zn2+ concentrations After 15-20 min of incubation with 1 M Mito Tracker red (MitoTr), analysis of cZn2+ and mZn2+ concentration in OVCAR-3 cells was stained using RhodZin3/AM (1 M per milliliter) (Cat #: T24195, ThermoFisher Scientific), a fluorescent probe for Zn2+ labeling. Using the ZEN program and an LSM-800 confocal microscope (Ext: 526 nm, Emi: 404 nm), green pictures of RhodZin3/AM in the cells were taken. The fluorescence intensity changes in the green images were calculated using the ZEN program (blue edition 3.2), and the results were expressed as a.u. 2.12. Lysosome staining Using LysoTracker Green DND-26 (Cat. No: #8783, Cell Signaling), the vesicles seen in the cytoplasm were stained during a 24-hour incubation period with Cisp and EPA. Following a 15–20-minute incubation period with 1 µM Mito Tracker red (MitoTr), 50 nM of LysoTracker Green DND-26 (LysoTr) was added to the culture medium of the dishes. Following an additional 15–20-minute incubation period, live cell observations were made using an LSM-800 confocal microscope. Diode laser stimulations of MitoTr and LysoTr were kept at 561 nm and 488 nm, respectively. After digitally recording and consecutively seeing the red-emitting MitoTr and the green-emitting LysoTr, the fluorescence intensity variations as a.u. were examined using blue ZEN software. 2.13. Analysis of LPx, glutathione peroxidase (GSH-Px), and GSH Using a spectrophotometer (Shimadzu-UV1800, Kyoto, Japan), the total amount of protein, The optic density (absorbance) values of LPx [31], GSH [32], and GSH-Px [33] in the OVCAR-3 samples were calculated. GSH, LPx, and protein concentrations in OVCAR-3 were expressed using the measurement of M/g. The GSH-Px activity of OVCAR-3 cells has been expressed as a protein with an IU/g value. 2.14. Analyses of statistics The results were expressed as the means ± standard deviation (SD) for the specified number of experiments. The statistical significance was ascertained by using a one-way analysis of variance (ANOVA) in the SPSS program (version 24.0). The sig