灵敏度(控制系统)
反向
数码产品
热传导
材料科学
电气工程
电子工程
工程类
数学
复合材料
几何学
作者
Patrick Krane,David G. Cuadrado,Francisco Lozano,Guillermo Paniagua,Amy Marie Marconnet
出处
期刊:I-THERM
[Institute of Electrical and Electronics Engineers]
日期:2019-05-01
卷期号:: 504-510
被引量:6
标识
DOI:10.1109/itherm.2019.8757292
摘要
Inverse heat conduction methods can be used to estimate the location and intensity of heat sources in electronics, but often there is a tradeoff in computational cost and accuracy of the retrieved heat fluxes and temperatures. This is exacerbated when the exact size and locations of heat sources within the device are unknown. This paper demonstrates the applicability of an inverse sensitivity coefficient method to locate hotspots and estimate associate hot spot temperatures for a commercial electronics package. The sensitivity coefficients are computed with a steady-state, 3-D finite volume model in FloTHERM. In this work, the locations and sizes of the heat sources are not initially known, thus, we impose a grid of potential heater source locations on one surface, and activate the heaters located under the hot spots visible in the temperature profile. The inverse model is validated with the results of a “numerical experiment” (i.e., solving the direct problem in FloTHERM and using the temperature maps as input to the inverse solver) and used to identify hot spots in a commercial device using temperature maps acquired experimentally with infrared microscopy. While demonstrated here for a microelectronic device, this method is broadly applicable to other systems where the distribution of heat generation is unknown and limited only temperature measurements are experimentally possible including batteries and manufacturing processes.
科研通智能强力驱动
Strongly Powered by AbleSci AI