微流控
流离失所(心理学)
粘性指进
微模型
比例(比率)
材料科学
提高采收率
石油工程
环境科学
地质学
多孔介质
纳米技术
复合材料
物理
多孔性
量子力学
心理治疗师
心理学
作者
Duraid Al-Bayati,Matthew B. Myers,Ali Saeedi
标识
DOI:10.1134/s0965544124050104
摘要
Abstract For water-wet porous media, the literature revealed a poor displacement efficiency for CO2 relative to N2. The overall average residual water saturation displaced by CO2 is ~50.0% compared to ~20.0% displaced by N2. Furthermore, based on the “Land” trapping model (Land, 1968), the non-wetting phase trapped during a subsequent imbibition displacement would also be reduced due to the low end-point saturation of the non-wetting phase achieved during the drainage flood. In this study, we hypothesize that for a drainage flood with a very low viscosity ratio (μdisplacing/μdisplaced <<1) and low flow rate (ca < 10–6) (i.e., conditions that are typical for the displacement of water by CO2, N2 in a strongly water-wet porous media) the end-point residual water saturation is predominantly controlled by the interfacial tension of the fluid-gas system. To test our hypothesis, we have performed six pore-scale displacement experiments on a micromodel using both CO2 and N2 to understand the influence of different fingering mechanisms (i.e., capillary vs. viscous) on flooding performance. It is observed that, for capillary-dominated floods, IFT values control the displacement efficiency. Therefore, we could conclude for capillary experiments that the poor displacement of the non-wetting (i.e., CO2) is due to a snap-off model which is closely related to the IFT value.
科研通智能强力驱动
Strongly Powered by AbleSci AI