Magnetic Field‐Assisted Interface Embedding Strategy to Construct 2D/3D Composite Structure for Stable Perovskite Solar Cells with Efficiency Over 24%

Abstract Perovskite solar cells (PSCs) based on 2D/3D composite structure have shown enormous potential to combine high efficiency of 3D perovskite with high stability of 2D perovskite. However, there are still substantial non‐radiative losses produced from trap states at grain boundaries or on the surface of conventional 2D/3D composite structure perovskite film, which limits device performance and stability. In this work, a multifunctional magnetic field‐assisted interfacial embedding strategy is developed to construct 2D/3D composite structure. The composite structure not only improves crystallinity and passivates defects of perovskite layer, but also can efficiently promote vertical hole transport and provide lateral barrier effect. Meanwhile, the composite structure also forms a good surface and internal encapsulation of 3D perovskite to inhibit water diffusion. As a result, the multifunctional effect effectively improves open‐circuit voltage and fill factor, reaching maximum values of 1.246 V and 81.36%, respectively, and finally achieves power conversion efficiency (PCE) of 24.21%. The unencapsulated devices also demonstrate highly improved long‐term stability and humidity stability. Furthermore, an augmented performance of 21.23% is achieved, which is the highest PCE of flexible device based on 2D/3D composite perovskite films coupled with the best mechanical stability due to the 2D/3D alternating structure.