制作
简单(哲学)
材料科学
热电效应
紧迫的
光电子学
热压
工程物理
纳米技术
冶金
复合材料
工程类
医学
物理
热力学
病理
哲学
替代医学
认识论
作者
Jariya Lasiw,Teerasak Kamwanna,Supree Pinitsoontorn
出处
期刊:ChemNanoMat
[Wiley]
日期:2024-09-06
卷期号:10 (10): e202400319-
被引量:12
标识
DOI:10.1002/cnma.202400319
摘要
Silver selenide (Ag 2 Se) is a promising thermoelectric material for near‐room temperature applications. This study proposes a fast, simple, and cost‐effective method for producing high thermoelectric performance bulk Ag 2 Se. Ag 2 Se powders were synthesized from Ag and Se powders via a one‐hour wet ball milling process, followed by the fabrication of bulk pellets through low‐temperature hot‐pressing (130–250 °C) with a mere 0.5‐hour holding time. Both Ag 2 Se powders and bulk pellets exhibited a single phase of Ag 2 Se with an orthorhombic structure. Moreover, uniform compositional distribution with the stoichiometric Ag : Se ratio was observed in all samples. Microstructural analysis revealed distinct grain boundaries in samples hot‐pressed below 190 °C, transitioning to grain coalescence was at 190 °C and 250 °C. The thermoelectric and transport measurements demonstrated that the electrical conductivity decreased and the Seebeck coefficient increased with hot‐pressing temperatures from 130 °C and 190 °C primarily due to reduced carrier concentrations. Thermal conductivity decreased with increasing hot‐pressing temperatures up to 190 °C, attributed to the weak chemical bonding of Ag 2 Se and the presence of defects. This combination resulted in a peak zT over 1.0 at 300 K, with an average zT close to 1.0 from 300 to 380 K. In comparison to other reported synthesis methods, the present approach offers significantly reduced processing time, simplicity, and cost‐effectiveness. Despite lower temperatures and shorter processing times, the method produces Ag 2 Se with zT values comparable to more intricate techniques. This fabrication route holds the potential for scalable mass production in the future.
科研通智能强力驱动
Strongly Powered by AbleSci AI