带隙
材料科学
锐钛矿
纳米管
无定形固体
X射线光电子能谱
阳极氧化
费米能级
光电子学
纳米技术
化学工程
光催化
碳纳米管
结晶学
化学
复合材料
量子力学
物理
工程类
电子
催化作用
生物化学
铝
作者
Farzad Nasirpouri,PhD student (Ms) Naeimeh‐Sadat Peighambardoust,Alexander Sergeevich Samardak,Alexey Vyacheslavovich Ognev,V. V. Korochentsev,Ivan S. Osmushko,Russell Binions
标识
DOI:10.1002/celc.201700038
摘要
Abstract The application of TiO2 in energy‐harvesting materials has been restricted, owing to its relatively large bandgap. In accordance with theoretical predictions of lower bandgap and higher absorbance of visible light in TiO2 nanotube arrays, we demonstrate experimentally that large‐area TiO2 nanotube arrays produced either by low‐temperature anodization or by two‐step anodization on electropolished Ti exhibit a narrowed bandgap; reducing the bandgap from 3.2 to 2.92 eV in an amorphous (as‐anodized) state and to 2.84 eV in the anatase (annealed) phase. The bandgap energy of oxide nanotubes was measured by calculating Tauc plots, according to the diffuse reflectance spectra. Furthermore, the band structure of the TiO2 nanotube arrays measured by using X‐ray photoelectron spectroscopy and ultraviolet photoemission spectroscopy revealed similar bandgap narrowing evidence. This bandgap narrowing behavior can be attributed to either surface edge states, owing to the incorporation of oxygen atoms on the high surface area of the nanotubes, or the formation of Ti3+ defect states form nonbonding states within the bandgap below the Fermi‐level edge. Annealing the tubes further reduced the energy bandgap, owing to the formation of anatase crystalline phase.
科研通智能强力驱动
Strongly Powered by AbleSci AI