溅射
弹性后坐力检测
反冲
材料科学
分析化学(期刊)
扩散
氩
蒙特卡罗方法
溅射沉积
散射
基质(水族馆)
焊剂(冶金)
化学计量学
薄膜
原子物理学
化学
光学
热力学
纳米技术
物理
海洋学
地质学
有机化学
统计
冶金
色谱法
数学
作者
J. Neidhardt,Stanislav Mráz,Jochen M. Schneider,Erik Strub,Wolfgang Bohne,Bartosz Liedke,W. Möller,Christian Mitterer
摘要
The evolution of the coating stoichiometry with pressure, target-substrate distance, and angle was analyzed for dc sputtering of TixB (x=0.5, 1, 1.6) compound targets by elastic recoil detection analysis. For an investigation of the underlying fundamental processes primarily Ar was used as sputter gas. Additionally, the effect of a reactive gas (N2) as well as bias voltage (floating up to −200 V) was briefly cross-checked. For deposition along the target normal (90°) a pronounced Ti-deficiency of up to 20% is detected. Increasing the pressure or distance from 0.5 to 2 Pa and from 5 to 20 cm, respectively, leads to an almost equivalent linear increase in Ti/B ratio surpassing even the target composition. Off-axis depositions at lower angles (30° and 60°) on the other hand result in a higher Ti/B ratio. This is consistent with results obtained from Monte Carlo simulations combining the respective emission characteristics from the sputter process as well as the gas-phase transport. Hence, the pressure, distance, and sample position induced changes in chemical film composition can be understood by considering gas scattering and the angular distribution of the sputtered flux. The theoretically determined transition from a directional flux to thermal diffusion was experimentally verified by mass-energy analysis of the film-forming atoms.
科研通智能强力驱动
Strongly Powered by AbleSci AI