材料科学
激光器
皮秒
热的
复合材料
传热
机械加工
钻探
激光打孔
光学
冶金
机械
热力学
物理
作者
Xiaomao Sun,Xia Dong,Kedian Wang,Rujia Wang,Zhengjie Fan,Wenqiang Duan
标识
DOI:10.1016/j.optlastec.2018.12.020
摘要
Abstract Multilayer material drilling is an important technology in the machining of film cooling holes. In this paper, trepanning drilling of thermal barrier coated In718 with 532 nm picosecond laser was investigated with emphasis on thermal effects. We discussed the relationship between heat accumulation and processing parameters as well as the formation mechanism of resolidified layer. According to the experimental result, the repetition rate is the most significant factor to affect heat accumulation. By discussing the influence of repetition rate on plasma reheating and heat transfer-dissipation of the lattice, the formation mechanism of molten material accumulation around the entrance as well as the mechanism of the cylinder at the center of the hole was explained. Further study on defects of the side wall revealed the existence of a thin intermittent resolidified layer, which is quite different from the recast layer in long pulsed laser drilling. The difference in material removal mechanisms was the primary cause of this phenomenon. Discussion of this difference can provide references to the formation of defects as well as improve processing quality in the process of picosecond laser drilling on thermal barrier coated alloy.
科研通智能强力驱动
Strongly Powered by AbleSci AI