玻璃离子水门汀
材料科学
臼齿
牙冠(牙科)
复合材料
胶粘剂
空腔壁
锆
牙科
立方氧化锆
陶瓷
医学
冶金
图层(电子)
作者
Katarzyna Walczak,Stefan Rues,Mieszko Więckiewicz,Ursula Range,Marc Schmitter
出处
期刊:PubMed
日期:2016-01-01
卷期号:18 (4): 117-125
被引量:4
标识
DOI:10.5277/abb-00529-2015-02
摘要
To show the influence of retentive cavity, cavity wall preparation and different luting techniques on the fracture resistance of severely damaged teeth restored with adhesive core build-ups and monolithic zirconium crowns.Extracted molars were prepared with 2 mm ferrule height and divided into eleven groups (n = 8/group). In nine groups a retentive occlusal cavity with a width and depth of 1 or 2 mm was prepared. Two control groups without a retentive cavity were made. Zirconium crowns were manufactured. 48 copings were cemented with glass-ionomer cement (Ketac Cem), the others (n = 40) with adhesive resin cement (Panavia F 2.0). Artificial ageing was carried out in the following way: n = 88, thermocycling (10,000 cycles, 6° C/60° C), n = 80 chewing simulation (1,200,000 cycles, 64 N). The samples were tested for load at first damage and fracture load with non-axial force. For statistical analysis ANCOVA with post hoc, Bonferroni-adjusted t-test were used ( p ≤ 0.05).No differences between the tested cements were detected. Influence of the cavity wall thickness was significant ( p = 0.001). Mostly, the samples with wall thickness of 2 mm showed better results. Both control groups (no cavity) showed results comparable to study groups with cavity.Retentive cavity is most likely not mandatory. However, if prepared, the cavity wall thickness is of higher importance than cavity depth. Glass-ionomer and adhesive resin cement are comparable for use with zirconia crowns.
科研通智能强力驱动
Strongly Powered by AbleSci AI