已入深夜,您辛苦了!由于当前在线用户较少,发布求助请尽量完整地填写文献信息,科研通机器人24小时在线,伴您度过漫漫科研夜!祝你早点完成任务,早点休息,好梦!

ELECTRODEPOSITION AND SELENIZATION OF METALLIC THIN FILMS FOR KESTERITE SOLAR CELLS APPLICATION

作者
Alexandre Crossay
出处
期刊:University of Luxembourg - Open Repository and Bibliography [University of Luxembourg]
摘要

Thin films of Kesterite Cu2ZnSnSe4 (CZTSe) are prepared via a low energy cost and high material efficiency process, to be potentially used as light absorbers in solar cell devices. The fabrication process involves two main steps: (i) formation of a metallic stack of Cu/Sn/Zn by sequential electrodeposition of Cu, Sn and Zn onto glass/Mo substrates; (ii) reactive annealing at 550°C in presence of Se and SnSe powders to form Kesterite. This thesis mainly aims at understanding the mechanisms of metal alloying and selenization occurring during step (ii), and their effects on the microstructure of the final film, the presence of secondary phases and their distribution in the thin films synthesized. The second objective is to understand their effects on the solar cells parameters. The stoichiometry of the precursor layers Cu/Sn/Zn is deliberately chosen to be Cu-poor and Zn-rich (Cu/(Zn+Sn)<1 and Zn/Sn>1), as it allows to reach the best power conversion efficiencies. Under these conditions, Kesterite, SnSe2 and ZnSe are expected. However, a study of different compositions shows that the predominant phases present are only Kesterite and ZnSe. SnSe2 is not present because this phase is unstable under the conditions of selenization, which leads to a self-regulation of tin content via gas phase exchange of SnSe during the selenization. Analyses of the selenization of Cu/Sn/Zn layers at short times and lower temperatures allow to deconstruct the mechanism of Kesterite formation into sequential steps. Because of the diffusion of metals and the formation of alloys, a reorganization of metals is observed in the thin films. The layers are then composed of Sn, Cu-Sn and Cu-Zn phases mainly, which are found to be segregating at large scales of tens of micrometers. During selenium incorporation, a tin self-regulation process is established, in which tin is depleted during the first stages of selenization, and then tin is replenished. ZnSe segregates at the surface of the absorber layer as large islands of 10-20 micrometers. By analyzing a specific position of a sample after the different process steps, it is shown that the segregation of ZnSe at this large scale is originating in the segregation of metals during alloying. Because of the presence of ZnSe on the surface of the films, part of the photocurrent generated in the absorber layer is not collected, which decrases the short circuit current of the devices. In this sense, a linear decrease of short circuit current is observed when the ZnSe molar ratio is increasing, and confirmed by external quantum efficiency (EQE) measurements showing a decrease of current collected through the whole range of photon energies. An optimal molar ratio of ZnSe/(CZTSe + ZnSe)=0.2 is found. Below this value, the short circuit current decreases, probably due to the formation of other types of harmful secondary phases such as Cu2SnSe3 or Cu2Se. A strong decrease of open circuit voltage and fill factor of the solar cells is proved to be related to the formation of blisters in the thin films, which result in the creation of pinholes due to their fragility. Formation of these blisters is supposed to originate from hydrogen evolution under the Cu layer during the electrodeposition process. Finally, a study of an additional process of prealloying between the steps of electrodeposition and selenization is presented, which demonstrates the possibility to increase the open circuit voltage of the solar cells by varying the time of this alloying step. A best power conversion efficiency of 7.2% is achieved via this method, which is close to the highest value of 9.1% reported for an electrodeposition-based process of Kesterite synthesis.

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
刚刚
00hello00发布了新的文献求助10
1秒前
不是桥完成签到,获得积分10
6秒前
汉堡包的应助被当晚星散落采纳,获得10
7秒前
xy发布了新的文献求助10
7秒前
8秒前
8秒前
葳蕤一水完成签到 ,获得积分10
9秒前
态度完成签到 ,获得积分10
9秒前
11秒前
wanci的应助被初景采纳,获得10
12秒前
12秒前
科研通AI6.3的应助被和谐莛采纳,获得30
12秒前
喵喵完成签到,获得积分10
15秒前
hanjia315完成签到,获得积分10
15秒前
认真问柳发布了新的文献求助10
16秒前
丘比特的应助被DearWhite采纳,获得10
16秒前
希望天下0贩的0的应助被林夏采纳,获得10
16秒前
LH发布了新的文献求助10
17秒前
DTS发布了新的文献求助10
17秒前
科研通AI2S的应助被烂漫的冬寒采纳,获得10
18秒前
希望天下0贩的0的应助被777采纳,获得10
18秒前
搞怪世德发布了新的文献求助10
19秒前
20秒前
00hello00发布了新的文献求助10
23秒前
23秒前
xiezhihao完成签到,获得积分10
23秒前
24秒前
25秒前
25秒前
26秒前
xiezhihao发布了新的文献求助10
27秒前
27秒前
嘻歪歪关注了科研通微信公众号
28秒前
gkhsdvkb完成签到 ,获得积分10
28秒前
小蘑菇的应助被roy采纳,获得10
29秒前
紫罗兰完成签到,获得积分10
29秒前
靖松完成签到,获得积分10
30秒前
30秒前
林夏发布了新的文献求助10
30秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 2000
Sex, Aging, and Death in a Medieval Medical Compendium: Trinity College Cambridge MS R.14.52, Its Texts, Language, and Scribe 500
高分子基功能界面水蒸发材料与应用研究 500
外场增强的水汽发电研究 500
基于结构调控的功能化水诱导发电材料与器件研究 500
基于界面调控的高效湿气发电材料与器件研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8189722
求助须知:如何正确求助?哪些是违规求助? 9576968
关于积分的说明 21850792
捐赠科研通 7787717
什么是DOI,文献DOI怎么找? 3435771
关于科研通互助平台的介绍 2559813
邀请新用户注册赠送积分活动 2482641