The Use of Buffered Solutions in Staining: Theory and Practice

The importance of pH in staining tissue is emphasized. The effect of pH upon the selectivity and intensity of staining with iron hematoxylin, malachite green, and eosin Y is considered. Many difficulties may be avoided by staining in the higher alcohols and directions are given for the preparation of buffer solutions from pH 1.2-8 in alcohol. The concentration of stains, time of staining, and order of staining are discussed for progressive and regressive staining. At pH 8 in 95% alcohol very few tissues stain with malachite green at a concentration of 1/1000 saturated. At pH 6 most cytoplasmic elements stain with malachite green at a concentration of 1/1000 saturated or with eosin Y at 1/250 saturated. As the pH is lowered more tissue elements stain until the nucleus is completely stained. This behavior is in accord with the theory of chemical combination of dyes with proteins, which states that proteins combine with basic dyes on the basic side of their isoelectric points and with acid dyes on the acid side of their isoelectric points. With hematoxylin stain the pH range is much shorter. A satisfactory hematoxylin stain is composed of 0.1% hematoxylin, 0.1% FeCl3, and HCl to bring the pH to 1.2-1.6 in 80% alcohol. With this stain, which may be used immediately, the nuclei of most tissues begin to stain at pH 1.2 and much of the cytoplasm will be stained if the pH is raised to 1.4. The shortness of this effective pH range is thought to be due to the dissociation of the hematoxylin-iron-protein complex. The use of different dyes successively at different pH values, such as hematoxylin at 1.3, malachite green at 8, and eosin at 6, permits better differentiation of the tissue elements, and intelligent variations in the staining technic.