Prediction of welding residual stress and distortion in multi-layer butt-welded 22SiMn2TiB steel with LTT filling metal

The objective of this study is to investigate the influence of low transformation temperature (LTT) filling metal on residual stress and distortion in multi-layer butt-welded 22SiMn2TiB steel. A three-dimensional thermal elastic–plastic finite element model is developed for LTT filling metals, and metallurgical phase transformation is taken into account to predict the martensite fraction of the weld metal. A thermodynamic-based method is employed to calculate martensite start temperature (Ms) and the influence of dilution on Ms is also considered. Volume change due to austenite transformation during heating and martensite transformation during cooling are coupled with the numerical simulation of welding process. The evolution of welding residual stress and welding distortion are both predicted. The simulation results revealed that the distortion of welding plate using LTT filling metal is much smaller than that using austenitic metal. In the weld zone, transverse residual stress is lower using austenitic filling metal, but longitudinal stress is much smaller using LTT filling metal. Longitudinal stress distribution for both LTT and austenitic filling metals is very high in the heat-affected zone, which is close to the yield stress of base metal. The LTT filling metal can not only guarantee the strength of welded joint for armor steel, but also reduce the welding distortion obviously, and the residual stress is also very low at the same time. The predicted temperature profiles and welding distortion are generally in good agreement with the experimental ones.