The formation and composition of room-temperature surface oxides on (110) orientated InSb samples was studied with ESCA and AES. The oxides are composed of a mixture of In 2 O 3 and Sb 2 O 5 . It is shown that the Sb oxide is Sb 2 O 5 and not Sb 2 O 3 , as has been previously generally assumed. Four surface-preparation techniques were compared: free etching, mechanical polishing, chemo-mechanical polishing and anodic oxidation. Chemo-mechanical polishing and free etching yield comparable oxide thicknesses of about 30 AA. Mechanical polishing produces a 100 AA thick disturbed oxide layer. Anodic oxidation allows a choice of the thickness but introduces a strong carbon contamination. The first monocell layer of natural oxide grows very fast, within 80 s a 15 AA layer has formed. Thereafter the oxidation is diffusion controlled and much slower. From renormalisation curves it is concluded that the oxide mainly consists of In 2 O 3 with some Sb 2 O 5 . The In oxide stays near the oxide/bulk interface and finally after some 25 days stops further oxidation, while the Sb oxide moves towards the oxide/air interface. In contrast to thermal oxides no Sb layer is found at the oxide/bulk interface.