Three-Dimensional CeO2 Woodpile Nanostructures To Enhance Performance of Enzymatic Glucose Biosensors

Fabrication of detection elements with ultrahigh surface area is essential for improving the sensitivity of analyte detection. Here, we report a direct patterning technique to fabricate three-dimensional CeO2 nanoelectrode arrays for biosensor application over relatively large areas. The fabrication approach, which employs nanoimprint lithography and a CeO2 nanoparticle-based ink, enables the direct, high-throughput patterning of nanostructures and is scalable, integrable, and of low cost. With the convenience of sequential imprinting, multilayered woodpile nanostructures with prescribed numbers of layers were achieved in a "stacked-up" architecture and were successfully fabricated over large areas. To demonstrate application as a biosensor, an enzymatic glucose sensor was developed. The sensitivity of glucose sensors can be enhanced simply by increasing the number of layers, which multiplies surface area while maintaining a constant footprint. The four-layer woodpile nanostructure of CeO2 glucose sensor exhibited enhanced sensitivity (42.8 μA mM–1 cm–2) and good selectivity. This direct imprinting strategy for three-dimensional sensing architectures is potentially extendable to other electroactive materials and other sensing applications.