Effects of Process Parameters on Microstructure Evolution of Pure Aluminum Target under Clock 135° Collaborative Hot Rolling: A Simulation Study

Based on the results of current research and experiments, clock 135° hot rolling has been widely considered to be the preferred method in target rolling. However, it has been found that the process parameters are of vital importance during the rolling. Therefore, this work focuses mainly on the investigation of the effects of the roll speed ratio and offset distance on the microstructure evolution of a pure aluminum (Al) target under clock 135° collaborative hot rolling. Taking the ultra-thick pure Al metal circular billet as a research object, firstly, the evolutionary behavior of the effective strain (ES) and grain refinement for a rolled piece under the clock counterclockwise 135° synchronous and asynchronous (the speed ratios between rollers are set to be 1:1.05, 1:1.1, 1:1.2, respectively) rolling modes has been comparatively studied based on numerical simulation by DEFORM-3D software. It has been shown that a large ES value of 5.835 mm/mm is obtained in the lower surface layer by counterclockwise 135° asynchronous rolling with a roll–speed ratio of 1:1.2. Meanwhile, the average grain size below 80 µm accounts for ~61.8% of the total grains. These results demonstrate that the clock counterclockwise 135° asynchronous rolling method with a roll speed ratio of 1:1.2 should be an ideal strategy in obtaining finer grains. Unfortunately, nevertheless, the maximum degree of the bad plate shape is generated after forging by clock asynchronous rolling with a speed ratio of 1:1.2. As a consequence, clock counterclockwise 135° snake rolling with a 30 mm offset distance was proposed on the basis of a rolling speed ratio of 1:1.2, which perfectly corrected the warping plate shape caused by clock asynchronous rolling. What is more important, the minimum damage value of 1.60 was achieved accordingly. Meanwhile, the ES value increased in the core of the plate for the clock counterclockwise 135° snake rolling with all of the four offset distances compared to clock synchronous rolling. This study should be significantly conducive to guidance on setting process parameters in the industrial production of hot rolling metal or alloy targets.