燃烧室
导管(解剖学)
机械工程
空气动力学
涡轮机
燃烧室
工程类
燃气轮机
航空航天
涡轮叶片
航空发动机
静压
燃烧
水压试验
材料科学
流量(数学)
火箭发动机
结构工程
喷气发动机
陶瓷
入口
体积流量
推进剂
热电偶
核工程
涡轮机械
气流
陶瓷基复合材料
作者
Fumiaki Watanabe,Yosuke Mizokami,Akira Takahashi,Masaya Suzuki,Yoji Okita,Masahiro Hojo,Takashi Yamane
出处
期刊:ASME Turbo Expo 2016: Turbomachinery Technical Conference and Exposition
日期:2026-06-15
卷期号:: V001T02A001-
标识
DOI:10.1115/gt2026-176689
摘要
It is important to test new material components, such as ceramic matrix composite (CMC) turbine vanes, in an engine-simulated environment before actual engine testing, in order to mature the technology and reduce risks step by step. The authors developed a high-temperature CMC turbine vane as part of the “High-temperature, High-efficiency Turbine” technology developments in the En-Core (Environmentally Compatible Core Engine Technology Research) project, conducted by JAXA (Japan Aerospace Exploration Agency) from 2018 to 2024. In this technology development activity, high-temperature testing of the CMC turbine vane was conducted in a hot gas flow rig as a demonstration test to confirm the integrity of the CMC vane in an engine-simulated environment. This paper describes the design, preparation, and results of the test, including the CMC vane design and the rig test section duct design. The test was conducted using the High-Temperature & High-Pressure Combustion Test Facility at JAXA, which features a combustor inlet pressure of up to 5 MPa, an air flow rate of up to 4 kg/s, and an exit gas temperature of up to 1727°C (2000 K). The test was conducted using a single CMC vane with cooling holes. The gas passage geometry of the rig test section duct was designed to create a static pressure distribution similar to that in actual engines, in order to simulate the aerodynamic forces applied to the vane during engine operation. The rig test section duct was designed to allow cooling air to be introduced into the CMC vane. Before the demonstration test, preliminary tests were conducted in 2022. In the first preliminary test, thermocouples on the vane surface fell off during the test, and the temperature of the vane surface could not be measured. In the second preliminary test, the thermocouple installation was improved, and the temperature of the vane surface was successfully measured. The final demonstration test was conducted in 2023, reflecting the insights gained from the preliminary tests. The test was conducted for over 10 hours under conditions of a vane inlet gas temperature of 1550-1600°C, a vane inlet pressure of approximately 2 MPa, and a vane surface temperature exceeding 1300°C.
科研通智能强力驱动
Strongly Powered by AbleSci AI