Effect of particles on tensile and bending properties of jute epoxy composites

Abstract In this investigation, mechanical properties of composite materials produced from woven jute type were investigated. These composites were produced in the form of epoxy adhesive layers by using hand lay-up method in which aluminum, mica and ceramic particles were added into epoxy as a structural adhesive by 2, 4 and 6 wt%. Samples produced according to ASTM D procedures were subjected to tensile and three point bending loads to examine the effect of the particles. Experimental results were presented in tables and graphs. As a result, it was observed that the tensile and bending failure loads of the composite materials obtained by using the particle reinforced adhesive increased. Also, the biggest rise in tensile strength was achieved with 4 wt% aluminum and the biggest increase in bending strength was observed for 2 wt% aluminum particles.