Effect of welding current and speed on solidification cracking susceptibility in gas tungsten arc fillet welding of dissimilar aluminum alloys: Coupling a weld simulation and a cracking criterion

In order to study the effect of welding current and speed on the solidification cracking susceptibility of weld, gas tungsten arc welding of a fillet weld with a cold filler wire was simulated. Simulation was conducted for dissimilar welding of Al–Cu–Mg to Al–Mg–Si aluminum alloys with an Al–Mg filler metal at the welding current range of 145–175 A and welding speed of 18–24 cm/min. The outcomes of simulations, namely temperature gradient, velocity of isotherms, and weld chemical composition obtained for various welding currents and speeds, were used as inputs for a solidification cracking model. The results showed that the dimensions of the weld profile obtained from the simulation exhibited good agreement with experimental results. However, a discrepancy of 10–23% was observed between experimental and simulated results in relation to one dimension of the weld profile, i.e. the distance between the fillet weld corners. This discrepancy was addressed to identify the underlying reasons. According to the model proposed in this study for solidification cracking of aluminum alloys, both higher welding current and higher welding speed led to a higher susceptibility to solidification cracking. This result was justified by considering factors such as secondary arm spacing of dendrites, isotherm velocity, backfill time, and chemical composition and viscosity of the weld pool. Weldability tests were employed to validate the model's performance for predicting the solidification cracking susceptibility. Thus, the optimal welding parameters can be chosen in accordance with these results and production demands.