Ultrasonic Guided Wave Based Models, Devices and Methods for Integrated Structural Health Monitoring

Structural Health Monitoring (SHM) systems for future structures and vehicles would involve a process of damage identification and prediction of certain quantities of interest that concerns the function and safety. This process provides SHM systems the ability to not only save cost but also enhance the service life, safety and reliability of the structures and vehicles. Integrated SHM system (ISHM) is an advancement of SHM system that has additional capability of predicting the component life/failure. ISHM system development involves detailed understanding of diagnostic waves, hardware components, signal processing paradigms and intelligent use of algorithms. Diagnostic waves like the guided waves are the elastic waves that propagate in a direction defined by the material boundaries. These waves have the capability of traveling large distance probing the entire thickness in plates/shells. Thus, they are widely used by SHM systems in monitoring the plate structures. Piezoelectric transducers are often employed in the interrogation using guided waves. Most SHM systems employing guided waves are designed for specific structures. Current paradigms of SHM systems are unable to enable the transition from simple or ideal structures to realistic and complicated structures. This is due to the challenges at the fundamental level involving transducer, wave propagation and phenomena of guided wave scattering with damages to evaluate the possible solutions through mathematical modeling and signal analysis capability required by ISHM systems. This thesis aims to develop understanding of these problems at a fundamental level. Complex system level understanding is still needed which is left out as open problem. A primary requirement in designing SHM system is the proper understanding of wave characteristics such as number of modes, wavelength and dispersiveness. Although three-dimensional elasticity solution and simplified theories are available to understand them, their applicability in SHM problem requires a much more detailed look. Effort toward this direction has led to the development of simpler models. However, mathematical models are not available for understanding the wave characteristics in complex structures involving stiffeners and adhesive joints. This problem is addressed in this thesis. There is a fair amount of understanding developed regarding transducer characteristics. This is accomplished by analytical and finite element models of transducers in the past. However, simplified transducer model that are computationally fast to suit SHM system requirements needs to be developed. The development of such model is presented in this thesis. Apart from modeling the transducers and wave scattering due to damage, signal correlation and calibration are needed for practical implementation in SHM. Characterization studies reported in published literature are limited to quasi-static and low frequencies applications. However, SHM of aerospace structures employ guided waves typically in the frequency range of 100-500 kHz.…