材料科学
灵敏度(控制系统)
干涉测量
声压
振膜(声学)
声学
信号(编程语言)
压力传感器
光学
压力测量
聚二甲基硅氧烷
噪音(视频)
陶瓷
光纤传感器
频率响应
信噪比(成像)
光电子学
大气压力
光纤
纵向模式
温度测量
响应时间
动态范围
次声
声传感器
谐振器
航程(航空)
插入损耗
天文干涉仪
作者
Ziyan Ren,Xiaoshuai Zhu,Qingqing Xu,Ying Wang,Qiang Ling,Haiyun Chen,Zhangwei Yu,Daru Chen
标识
DOI:10.1109/jsen.2025.3634337
摘要
In the paper, a novel, all-fiber acoustic sensor utilizing a Fabry-Perot interferometer is proposed, which is composed of a single mode fiber (SMF) integrated with a gold and polydimethylsiloxane (PDMS) composite film. The SMF is inserted into a homemade, 3D-printed ceramic sleeve, and the cavity length can be adjusted nimbly by controlling the distance from the SMF to the gold film. Considering the significant correlation between sensitivity and film thickness in theory, an investigation is conducted into the influence of varying PDMS thicknesses on the acoustic pressure sensitivity of the sensor experimentally. Through the precise regulation of the rotational speed, four PDMS thin films with varying thicknesses are fabricated by a commercial gluing machine. The experimental results indicate that the maximum acoustic pressure sensitivity can reach 1.341 V/Pa. Moreover, our sensor exhibits a flat frequency response range spanning from 1 kHz to 16 kHz, with the highest signal to noise ratio attaining 75 dB at 14 kHz. The noise-limited minimum detectable pressure level of 12.14 μPa/Hz1/2@14 kHz can be achieved in air, and the applied sound pressure is 68.55 mPa. Owing to its simplicity, low cost, and high signal to noise ratio, this sensor is a promising choice in the field of sound detection.
科研通智能强力驱动
Strongly Powered by AbleSci AI