材料科学
复合材料
电介质
聚偏氟乙烯
钛酸钡
复合数
填料(材料)
介电损耗
拉曼光谱
结晶
陶瓷
介电常数
聚合物
化学工程
物理
光电子学
光学
工程类
作者
Vladimir Djoković,Duško Dudić,Radovan Dojčilović,Filip S. Marinkovic,Vera P. Pavlović,Vladimir B. Pavlović,Branislav Vlahović
出处
期刊:Physica Scripta
[IOP Publishing]
日期:2023-10-02
卷期号:98 (11): 115932-115932
被引量:4
标识
DOI:10.1088/1402-4896/acff4d
摘要
Abstract Barium titanate (BT) perovskite particles were surface modified by means of mechanical treatment and used as inorganic component in polyvinylidene fluoride (PVDF) based composites. The changes in electrical properties of the composite films with increasing in filler content were followed by dielectric spectroscopy, breakdown strength and D-E measurements. A comparison of the properties of the composites prepared with untreated and mechanically activated particles revealed that there is a significant difference in their performances at low filler concentrations (<20 wt%). Introduction of the surface modified ceramic particles into PVDF matrix led to an increase of the dielectric constant without affecting significantly the electrical breakdown strength. In contrast, when as received BT particles were used a filler, both dielectric constants and breakdown strengths of the composite films were lower than the corresponding values observed for the pure PVDF. At higher concentrations, however, the influence of pre-treatment of the filler on the effective electrical properties becomes less significant. The obtained results were discussed in terms of the pronounced crystallization of polar β and γ crystal phases of PVDF in the presence of surface modified BT fillers, which is confirmed by Raman spectroscopy.
科研通智能强力驱动
Strongly Powered by AbleSci AI