材料科学
导线
电流计
光学
磁道(磁盘驱动器)
边界(拓扑)
曲面(拓扑)
激光器
脉冲激光器
点(几何)
放大倍数
分析器
多模光纤
GSM演进的增强数据速率
强度(物理)
射弹
纳秒
作者
Weijun Liu,Dong Zhang,Wei Wang,Qiang Li
出处
期刊:Coatings
[Multidisciplinary Digital Publishing Institute]
日期:2026-10-10
卷期号:16 (10): 1203-1203
标识
DOI:10.3390/coatings16101203
摘要
Wide-area laser cleaning requires uniform surfaces within individual cleaning tracks and across their boundaries. This study investigated the effects of traverse speed, galvanometer scan frequency, and track overlap on 0.5 mm thick TC4 sheets cleaned with a 1000 W multimode nanosecond laser. Increasing traverse speed from 4 to 8 mm/s at 9 Hz reduced surface crack networks, while scan frequencies of 12–15 Hz improved surface uniformity at 6 mm/s. A supplementary experiment at 8 mm/s and 15 Hz yielded a representative EDS point oxygen content of 6.77 wt.%. The mean edge transition width was 493 μm, corresponding to a geometric overlap estimate of 0.986 mm. However, a distinct boundary and local oxygen enrichment persisted at a 1 mm overlap. Across three independent experiments, the mean oxygen contents of the overlap regions were 12.15 ± 1.02 wt.% at 1 mm and 7.68 ± 0.20 wt.% at 2 mm after excluding suspected acquisition anomalies. Fine cracks remained visible at 500× magnification at 2 mm, whereas no boundary was discernible in the observed SEM field at 3 mm. At 8 mm/s and 15 Hz with a 100 mm scan length, 2 mm was the smallest tested overlap that satisfied the combined morphological and relative oxygen-content criteria. This result provides an operating recommendation for the tested conditions and shows that geometric coverage alone is insufficient to ensure boundary uniformity.
科研通智能强力驱动
Strongly Powered by AbleSci AI