材料科学
复合材料
艾氏冲击强度试验
复合材料层合板
法律工程学
结构工程
热成像
冲击能
抗冲击性
压缩(物理)
作者
Ewan Cameron,Aleksandr V. Zinoviev,H. Kleine,Matthew Doolan,Olga Zinovieva
标识
DOI:10.1016/j.compositesb.2026.113901
摘要
Limited research has examined the impact response of printed continuous fibre reinforced polymer composites (CFRPCs) under blast-like and puncture loading, particularly when post-processing is applied. This study examines 3D-printed Kevlar CFRPCs manufactured with a 0°/90° fibre layup and nylon-based chopped carbon fibre matrix. Samples were subjected to thermomechanical post-processing under temperature–pressure combinations of 150–200 °C and 250–1000 kPa, followed by quenching. Performance was evaluated using complementary tests: air shock wave loading in a closed-end shock tube configuration with high-speed imaging and pressure measurements to quantify transient deflection; quasistatic four-point bending to measure flexural strength and modulus; and low velocity impact to quantify peak force and puncture energy. Post-processing temperature governs the response more strongly than pressure. Relative to as-printed CFRPC, treatment at 200 °C reduced shock-induced deflection by up to 69.2%, eliminated edge delamination in shock tube tests, and increased flexural strength by 34.0% and stiffness by 50.7%. Under puncture impact, the 200 °C condition exhibited a more progressive, extended load-bearing response, an +86.6% increase in puncture energy compared to as-printed samples, and a similar performance to a wet lay-up Kevlar/epoxy laminate. The improvements are associated with reduced interbead porosity, enhanced fibre wetting and suppressed interfacial delamination observed using microscopy and with thermally-induced nylon polymorphic evolution from a mixed γ / α structure to the complete α phase revealed using X-ray diffraction. Thermomechanical post-processing near the melting regime can shift printed Kevlar CFRPCs from interface-limited failure towards a more damage-tolerant response under blast-like and point-impact loading.
科研通智能强力驱动
Strongly Powered by AbleSci AI