Additive manufacturing low shrinkage Si-based composite ceramics with SiCO microsphere/polyvinyl silicon acetylene slurry

In this paper, SiCO microsphere/polyvinyl silicon acetylene slurry was prepared for the first time with low viscosity and good rheological behavior. The dispersion of microspheres in the precursor resin and the UV-light curing performance of the slurry were investigated. After pyrolysis at 1000 °C, the properties of the three-dimensional (3D) printed samples were characterized. The introduction of SiCO microspheres reduced the specimen shrinkage of the pure precursor photosensitive resin used for additive manufacturing and improved their mechanical properties. When the addition of SiCO powder increased from 0 wt% to 10 wt%, the linear shrinkage decreased from 33 % to 26 %, and the flexural strength increased from 43.9 MPa to 79.8 MPa. This study realizes the preparation of Si-based composite materials through low-cost LCD additive manufacturing technology. It confirms the great potential of low-cost light-curing additive manufacturing to fabricate complex functional composite ceramic materials.