材料科学
因科镍合金
拓本
涂层
复合材料
冶金
高温合金
摩擦学
热的
粉末涂料
作者
Andrea Cappella,Baptiste Martinet,S. Philippon
出处
期刊:Wear
[Elsevier BV]
日期:2026-08-05
卷期号:604: 206951-206951
标识
DOI:10.1016/j.wear.2026.206951
摘要
This study investigates the thermomechanical damage mechanisms of a CoNiCrAlY-hBN abradable coating (M2043 from Oerlikon Metco) under high-speed and high-temperature interactions with an Inconel 718 rubbing tool. Single-pass contacts were reproduced using a ballistic test rig at a mean velocity of 125 m/s and coating surface temperatures close to 500 °C and 700 °C. In situ force and temperature measurements were combined with postmortem surface and subsurface analyses, including microscopy, three-dimensional profilometry, and X-ray computed tomography. The measured force signals exhibited comparable magnitudes and evolution at both temperatures, indicating a limited influence of the initial thermal state on the mechanical response of the contact. In contrast, the thermal response depends on the initial coating temperature, revealing differences in local heat generation and transfer during incursion. Surface analyses revealed pronounced material transfer from the Inconel 718 tool to the coating, which was associated with localized frictional heating. Microtomographic observations demonstrated that these surface processes promoted significant subsurface densification, characterized by pore collapse and compaction of the metallic matrix extending up to approximately 1 mm below the contact surface. These results show that under high temperature and high-speed single-pass interaction against an Inconel 718 rubbing tool, thermomechanically assisted densification appears as a key wear mechanism in M2043 abradable coatings, beyond surface wear alone.
科研通智能强力驱动
Strongly Powered by AbleSci AI