Influence of Systematic Incorporation of Conjugation-Break Spacers into Semi-Random Polymers on Mechanical and Electronic Properties

An extensive family of semi-random polymers was prepared via Stille polycondensation with varying contents of alkyl spacers incorporated into the polymer backbone to serve as a break in conjugation. This family was investigated to determine the effect of alkyl spacer length and percent incorporation on the optical, electronic, and mechanical properties. The optical bandgap was found to steadily increase from 1.53 to 1.70 eV as the amount of spacer was increased from 10 mol percent to 40 mol percent while the length of the spacer had little to no effect. In space charge limited current (SCLC) carrier mobility measurements, hole mobility was found to decrease as the amount of spacer increased but was found to steadily increase as the length of the spacer was increased from 6 to 10 carbons. Mechanical properties were observed by film-on-elastomer and film-on-water measurements, with low elastic moduli and high ductility attributed both to the break in conjugation as well as the semi-random structure of the polymer backbone. Measurements of the mechanical properties using the buckling method revealed elastic moduli between 0.14 and 1.3 GPa, and several polymers, when bonded to an elastomeric substrate, could be stretched beyond 80% strain. These polymers were further tested as free-standing films by obtaining a pull test on the surface of water, where we obtained tensile moduli between 0.13 and 0.75 GPa. These results indicate that semi-random polymers with conjugation-break spacers are promising candidates for further study in flexible electronics.