摘要
Dysphagia is common among the elderly and may cause food aspiration, malnutrition, and reduced quality of life, raising significant interest in food science. It is crucial to develop texture-modified foods that support safe swallowing and nutrient intake. Emulsion gels, due to their soft texture and tunable flow properties, help improve swallowing safety and act as an effective nutrient carrier. Moreover, protein–polyphenol-based encapsulation not only effectively loads and protects lipophilic active compounds but also enhances the stability and texture of the gel system.Rice glutelin, with its well-balanced amino acid profile, low allergenicity, excellent biocompatibility, and tunable functional properties, serves as a high-quality plant-based protein raw material. Studies have shown that rice glutelin can undergo controlled self-assembly under specific physical or chemical conditions, forming various nanostructures such as nanofibrils or nanoparticles. However, the mechanisms underlying the self-assembly behavior of rice glutelin and the influence of different assembled structures on emulsion stability remain unclear. Additionally, the effects of its complexation with polyphenols on the formation mechanism, rheological properties, and protective capacity for lipophilic active molecules in emulsion gels have yet to be systematically investigated. This project aims to examine how rice glutelin self-assembles under various conditions and influences emulsion stability. It further investigates how protein–polyphenol complexes affect the stability and rheology of emulsion gels, to support the design of robust and tunable gel systems. The encapsulation efficiency and bioaccessibility of lipophilic bioactive compounds will also be evaluated to improve nutrient utilization. Finally, the developed gels will be assessed following IDDSI guidelines to ensure safe swallowing, supporting the design of tailored texture-modified foods for dysphagia management. In the first part, rice glutelin was purified to a high protein content. Rice glutelin fibrils were successfully prepared under optimal conditions (2%, pH 2.0, 90 °C, 24 h) and characterized using Thioflavin T fluorescence and fibril conversion rate. The linear structure and improved water solubility were determined using TEM and small-angle X-ray scattering (SAXS). The isoelectric point (pI) of native rice glutelin (3.3) was lower than that of its fibrillar form (5.5). Amino acid content results showed that both rice glutelin and rice glutelin fibrils exhibited high amino acid content, confirming their value as high-quality protein sources. Finally, the concentration-dependent effects on interfacial behavior, foaming properties, and foam stability were evaluated. All prepared fibrils effectively adsorbed at the air–water interface and formed solid-like films. At a concentration of 0.25%, the fibrils already showed excellent foaming capacity, which did not improve with higher concentrations. The resulting foam also exhibited high stability. These results indicate that the rice glutelin was an excellent plant-based protein resource, and glutelin fibrils can serve as an effective foaming agent.In the second part, the influence of fibril concentration on the interfacial behavior at the oil-water interface and the mechanisms of emulsion stabilization was evaluated. The adsorption behavior of RGFs was characterized using dilatational rheology. RGFs were excellent Pickering stabilizers. All RGFs can effectively adsorb at the oil-water interface and form solid-like films at the oil-water interface. And the interfacial structure was observed using confocal laser scanning microscopy (CLSM), and cryo-scanning electron microscopy (Cryo-SEM). All fibrils can effectively adsorb at the oil-water interface. Emulsion stabilization mechanisms and storage stability were evaluated by analyzing the turbiscan stability index (TSI), particle size distribution, microstructure, and rheological properties. The average droplet sizes decreased from 0.1% to 0.5% and had no significant changes above 0.5%. Fibril concentration above 0.5% was sufficient to achieve a full surface coverage. Increasing fibrils from 0.1% to 1.0% enhances the viscosity and viscoelasticity of emulsions. This part established a relationship between particle concentration, interfacial adsorption properties, and emulsion stability. In the third part, rice glutelin will be treated with trypsin under controlled conditions. HRGFs were successfully prepared and characterized using SDS-PAGE, ThT fluorescence, and TEM. The optimized preparation condition was by heating 2% hydrolyzed rice glutelin aqueous solution at pH 2.0 and 90℃ for 24 h. Enzymatic treatment promoted fibril formation by reducing protein size and shortening the lag phase. The isoelectric points of HRG and HRGFs are 4.5 and 5.2, respectively. The structural evolution during fibril formation involves the disruption of intramolecular hydrogen bonds followed by newly formed intermolecular hydrogen bonds.In the fourth part, fibrils, particulates, and amorphous self-assemblies of rice glutelin (RG) were prepared, and their interfacial films were evaluated using interfacial dilatational rheology, Lissajous curves, and general stress decomposition (GSD) analyses. Additionally, the bulk rheology of emulsions stabilized by RG assemblies was assessed via mechanical and micro-rheological measurements. The results showed that RG fibrils exhibited a faster adsorption rate (0.72 mN/m/s1/2) and penetration rate (3.03 × 104 s−1), whereas RG particles showed a higher rearrangement rate (9.19 × 104 s−1). All assemblies formed solid-like viscoelastic interfacial films that displayed both strain hardening and softening under expansion and compression in the nonlinear regions. GSD analysis revealed that the interfacial behavior of RG fibrils was primarily governed by network formation, while that of RG particles was more strongly influenced by surface density. In the bulk phase, RG fibrils generated the most stable emulsions by forming elastic interfacial films and a dense network structure, characterized by high complex viscosity and storage modulus, which effectively prevented droplet coalescence and restricted droplet mobility. These findings advance our understanding of how protein architectures stabilize emulsions and support their targeted application in designing emulsion-based foods.In the last part, a novel emulsion gel system using HRG aggregates complexed with EGCG loaded with β-carotene was studied and applied in dysphagia management. The complexes were characterized by ζ-potential, surface hydrophobicity, and FTIR analysis. HRGFs-EGCG complex showed the highest ζ-potential value. According to the CLSM and Cryo-SEM, all samples effectively stabilized at the oil droplet interface and formed a uniform droplet size. After loading with β-carotene, FECLEs showed the highest encapsulation efficiency and optimal retention rate. And all emulsion gels improved the FFA of lipids and bioaccessibility of β-carotene complexed to MCT-β-carotene. Rheological results indicated that all emulsion gels exhibited shear-thinning behavior and solid-like viscoelastic structures. IDDSI tests evaluated that all emulsion gels were suitable for individuals with chewing or swallowing difficulties.