PREPARATION AND CHARACTERIZATION OF ULTRA-HIGH MOLECULAR WEIGHT POLY(ETHYLENE TEREPHTHALATE)(PET)FIBER

This paper reports the spinning and drawing behavior of Ultra-high Molecular Weight polyethylene Terephthalate) (UHMW-PET) fibers. The as-spun fibers were produced by dry-jet wet spinning of a 15%-17% solution in 50:50(v:v) trifluroroacetic acid and dichloromethane. Both molecular weight and polymer solution concentration have marked effect on the drawability of the as-spun-fibers. The maximum extension drawing ratio (EDRmax) of as-spun fiber increases with increasing molecular weight, whereas optimal concentration to achieve the EDRmax of as-spun fibers decreases with increasing molecular weight. Drawing speed and temperature during the first step have remarkable effect on the drawability of these fiber during the second step. Relatively lower drawing temperature and drawing speed (19 ℃ , 60 mm/min) during the first drawing step was beneficial to mechanical properties of ultimate fibers. At the range of 210 ℃ to 230 ℃, the draw ratio (DR) during the second step increases with increasing temperature.