Influence of pyroxene and spinel on the kinetics of peridotite serpentinization

Abstract Hydrothermal experiments were performed at 311°C and 3.0 kbar on natural olivine and peridotite to investigate the kinetics of serpentinization. The results show that the rates of reaction strongly depend on grain sizes of solid reactants, with smaller grain sizes resulting in faster kinetics. After 27 days of reaction, the reaction extent was 99% for peridotite with grain sizes of <30 μm, and the reaction extent was 28% for grain sizes of 100–177 μm. Compared to peridotite, olivine is serpentinized at much slower rates, e.g., 5.3% of reaction extent was achieved for olivine with grain sizes of 100–177 μm after 27 days, approximately five times lower than that reached during peridotite serpentinization. Such contrasting results are due to the presence of pyroxene and spinel, an interpretation which is supported by a marked increase in reaction extents for experiments with the addition of pyroxene and spinel. The reaction extent achieved in experiments with 3 wt % spinel greatly increased to 98% after 27 days, much higher than that achieved during olivine serpentinization. These results appear to be related to pyroxene and spinel releasing Al and Cr during serpentinization. As indicated by compositions of serpentine, orthopyroxene lost ~60% of Al at a reaction extent of 59%. Influence of Al and Cr is suggested by a dramatic increase in reaction extents with the addition of Al 2 O 3 and Cr 2 O 3 powders. Olivine in natural geological settings is commonly associated with pyroxene and spinel; consequently, serpentinization kinetics may be much faster than previously thought.