材料科学
热电效应
热导率
塞贝克系数
复合数
声子
电阻率和电导率
复合材料
体积分数
凝聚态物理
热力学
物理
工程类
电气工程
作者
Ashutosh Kumar,Preeti Bhumla,Artur Kosonowski,Karol Wolski,Szczepan Zapotoczny,Saswata Bhattacharya,Krzysztof T. Wojciechowski
标识
DOI:10.1021/acsami.2c11369
摘要
High Resolution Image Download MS PowerPoint Slide The preparation of composite materials is a promising methodology for concurrent optimization of electrical and thermal transport properties for improved thermoelectric (TE) performance. This study demonstrates how the acoustic impedance mismatch (AIM) and the work function of components decouple the TE parameters to achieve enhanced TE performance of the (1- z )Ge 0.87 Mn 0.05 Sb 0.08 Te-( z )WC composite. The simultaneous increase in the electrical conductivity (σ) and Seebeck coefficient (α) with WC (tungsten carbide) volume fraction ( z ) results in an enhanced power factor (α 2 σ) in the composite. The rise in σ is attributed to the creation of favorable current paths through the WC phase located between grains of Ge 0.87 Mn 0.05 Sb 0.08 Te, which leads to increased carrier mobility in the composite. Detailed analysis of the obtained electrical properties was performed via Kelvin probe force microscopy (work function measurement) and atomic force microscopy techniques (spatial current distribution map and current–voltage ( I–V ) characteristics), which are further supported by density functional theory (DFT) calculations. Furthermore, the difference in elastic properties (i.e., sound velocity) between Ge 0.87 Mn 0.05 Sb 0.08 Te and WC results in a high AIM, and hence, a large interface thermal resistance ( R int ) between the phases is achieved. The correlation between R int and the Kapitza radius depicts a reduced phonon thermal conductivity (κ ph ) of the composite, which is explained using the Bruggeman asymmetrical model. Moreover, the decrease in κ ph is further validated by phonon dispersion calculations that indicate the decrease in phonon group velocity in the composite. The simultaneous effect of enhanced α 2 σ and reduced κ ph results in a maximum figure of merit ( zT ) of 1.93 at 773 K for (1- z )Ge 0.87 Mn 0.05 Sb 0.08 Te-( z )WC composite for z = 0.010. It results in an average thermoelectric figure of merit ( zT av ) of 1.02 for a temperature difference (Δ T ) of 473 K. This study shows promise to achieve higher zT av across a wide range of composite materials.
科研通智能强力驱动
Strongly Powered by AbleSci AI