期刊:World Conference on Photovoltaic Energy Conversion [Institute of Electrical and Electronics Engineers] 日期:2018-06-01卷期号:: 0381-0385
标识
DOI:10.1109/pvsc.2018.8547824
摘要
The determination of the spectral responsivity is an essential part of solar cell calibration. Apart from the complete differential spectral responsivity procedure, which yields the most accurate results, the IEC 60904-8 defines four simplifications. We provide detailed information on the expected variations in the calculated spectral responsivity curves for the different simplifications compared to the complete procedure. For non-linear crystalline silicon front junction solar cells, we show that deviations mainly occur at wavelengths above 700 nm and become largest between 1000 to 1200 nm. Even though we found a maximum deviation in spectral responsivity of 7% for the simplification with lowest requirements in bias irradiance, all other simplifications yield deviations well below 3%. This transforms into a deviation of 0.01% in the spectral mismatch factor for an industrial PERC solar cell when using a typical world photovoltaic scale (WPVS) reference solar cell and a class A two-lamp solar simulator. If you are reliant on the use of a simplification, we recommend using the multicolour approach. Even though the singlecolour approach might yield lower deviations in specific cases, it requires knowledge about the maximum in the spectral responsivity, which is not generally known in advance of the measurement. Accepting a slightly higher deviation, the white bias approach is a recommendable alternative.