An important issue in using thinner multi crystalline silicon wafers for solar cell manufacture is the reduced yield due to higher wafer breakage rates. Wafer/cell breakage depends on the stresses produced in the handling and transport and on the presence of structural defects such as cracks. The types of loading results in different mechanical strength for the sample amplitude (e.g. usually static loading is less critical than vibration). One of the important loading types which have not been focused in the literature is vibration of wafers during handling. This paper presents a systematic approach for the analysis of the response of crystalline silicon wafers to rapid local loading similar to gripping by a suction pad. Various load paths have been considered. The paper highlights the key parameters to consider for this type of loading. In particular, it has been found that the rate of loading causing the vibration during handling is very important.