Defect detection in additively manufactured AlSi10Mg and Ti6Al4V samples using laser ultrasonics and phase shift migration

Laser ultrasonics (LU) is a non-contact and non-destructive method with a high data acquisition rate, making it a promising candidate for in-situ monitoring of defects in different additive manufacturing (AM) processes, including laser powder bed fusion (LPBF) and directed energy deposition, as well as final part inspection. In order to see the effect of various artificial defect types on an LU sub-surface reconstruction, AlSi10Mg samples with side through-holes, as well as Ti6Al4V samples with bottom blind holes and trapped powder were printed using LPBF, and then ultrasound B-scans of the samples were obtained using an LU system. The resulting scan data was processed using a custom frequency domain phase shift migration (PSM) algorithm, to reconstruct the defects and their locations. Novel ways of pre-processing the B-scan, used as an input to PSM, and taking advantage of its frequency representation, are demonstrated. Newton's method was used to find a stationary phase approximation, used to account in the frequency domain for the fixed offset emitter-receiver arrangement within the PSM calculation. The Newton's method calculation time was reduced by 33%, by using an approximation of the phase function to find an initial guess. The smallest defects that were detected using this method were in the size range between 200 to 300μm for the bottom hole defects, using an 8 ns laser pulse duration. The effect of the laser on the surface of a part being built, and the challenges and further work needed to integrate LU in a LPBF machine for in-situ inspection are discussed.