Low-adhesive superhydrophobic surface-enhanced Raman spectroscopy substrate fabricated by femtosecond laser ablation for ultratrace molecular detection

Ultratrace molecular detections from a limited amount of highly diluted solutions can offer unprecedented benefits in the biomedical/analytical fields, such as in precancer diagnosis, forensic analysis, and food safety. However, huge difficulties exist in completely concentrating the target molecules within a sensitive area and thereby enhancing the detection sensitivity. Herein, we report the ultratrace molecular detection using a low-adhesive superhydrophobic surface-enhanced Raman spectroscopy (LAS-SERS) substrate fabricated by femtosecond laser ablation. The LAS-SERS substrate has good characteristics, including a contact angle as high as 154°, a contact angle hysteresis below 5°, and a simulated Raman signal enhancement factor of up to 6 × 106. Compared to the previously developed superhydrophobic SERS (S-SERS) methods, the low-adhesive nature of the LAS-SERS method can greatly reduce the final contact area, thus significantly enhancing the detection limit. In our experiments, the final contact area of the LAS-SERS substrate was reduced by 19.5 times, corresponding to an 88.1 times increase in the concentration effect, as compared to the highly adhesive S-SERS substrates fabricated using the same technique. The enhanced condensation effect led to a detection limit as low as 10-14 M, which shows an obvious improvement compared to that of the other non-photolithography methods. The method reported herein offers a facile and efficient approach to the cost-effective fabrication of a high-performance LAS-SERS substrate for ultratrace molecular detection.