残余油
肺表面活性物质
化学
钙
润湿
盐度
饱和(图论)
表面张力
提高采收率
矿物学
离子强度
离子键合
水溶液
化学工程
材料科学
复合材料
离子
地质学
热力学
物理化学
海洋学
有机化学
生物化学
工程类
数学
物理
组合数学
作者
Hamid Hosseinzade Khanamiri,Ole Torsæter,Jan Åge Stensen
出处
期刊:Energy & Fuels
[American Chemical Society]
日期:2016-09-07
卷期号:30 (10): 8114-8124
被引量:28
标识
DOI:10.1021/acs.energyfuels.6b01236
摘要
Interfacial tension (IFT) between crude oil and surfactant solution at low salinity is normally higher than IFT at optimal ionic strength. However, it is possible to further reduce IFT by 1–2 orders of magnitude by changing the molar ratio of calcium to sodium cations (Ca 2+ /Na + ) at a constant low ionic strength in a low-salinity surfactant (LSS) solution. IFTs of 0.03 and 0.1 mN/m were measured at a Ca 2+ /Na + ratio of 0.005 and in the absence of calcium in LSS solutions, respectively. Two flooding experiments using these fluid systems were performed on a strongly water-wet Berea sandstone. The in situ core flooding in micro-computed tomography showed that more oil was trapped in the presence of calcium and that the residual oil clusters were larger after LSS injection. The results showed that there was a small wettability shift from being strongly water-wet toward being (weakly) water-wet by LSS flooding both with and without calcium. The results also showed that this wettability shift was stronger in the absence of calcium in the injected LSS, causing a reduction in the oil trapping. However, in the secondary low-salinity water flooding, the residual oil saturation was smaller in the presence of calcium. The cause of these behaviors is discussed in relation to the oil–surfactant and oil–water interfacial elastic modulus with initial rock wettability.
科研通智能强力驱动
Strongly Powered by AbleSci AI