润湿
材料科学
表面改性
聚合物
化学工程
结晶度
无定形固体
接触角
扫描电子显微镜
纳米技术
微观结构
乙二醇
复合材料
有机化学
化学
工程类
作者
Athira Marath Karthikeyan,Mélanie Girard,Marie‐Josée Dumont,Gérald Chouinard,Jason Robert Tavares
标识
DOI:10.1021/acs.iecr.2c02502
摘要
Poly(lactic acid) (PLA) is a promising environmentally friendly candidate to replace petroleum-based polymers. However, its inherent hydrophilic wettability is a drawback for applications in the textile and packaging industry, and outdoor applications such as exclusion nets on plants. Even though researchers have successfully altered the wettability of tightly controlled amorphous PLA samples in the lab, none have yet reported the modification of commercial PLA. The goal of this article was to develop an easily scalable surface modification technique to alter the wettability of commercially available, highly crystalline PLA. In this work, a surface modification technique─called dip-dip-dry (DDD)─previously validated for amorphous three-dimensional (3D)-printed PLA, has been optimized for transforming the wettability of commercially available PLA material. Herein, we utilized a short preheat treatment in ethylene glycol to reduce the surface crystallinity (confirmed via X-ray diffraction analysis) to enable microstructure formation using acetone/water as a solvent/coagulant sequence. The change in wettability from hydrophilic to superhydrophobic has been attributed to an increase in surface roughness, with the change in surface topography confirmed using scanning electron microscopy.
科研通智能强力驱动
Strongly Powered by AbleSci AI