Influence of operating parameters on the yield of micro-plastics from plastics incineration

Plastics account for a large proportion of domestic waste. However, micro-plastics will be produced after the plastic is incinerated. The purpose of this study is to find out the change rule of micro-plastics produced during incineration under different conditions. Combining micro-FTIR and PCA algorithm is a good tool to identify the micro-plastics. The PE, PP and PVC micro-plastics are distinguished using PCA-FTIR spectra. The results show different incineration conditions significantly affect the output of micro-plastics. The yield of micro-plastics increases with increasing temperature for both PP and PVC. And the yield of micro-plastics decreases with the increase in flow rate. The maximum amount of micro-plastics is produced by PE, which is 6.62 × 103 after 1 g PE incineration. The yield of micro-plastics in the co-incineration of PE and PP, as well as PE and PVC, significantly increased to 1.42 and 1.89 times of the calculated values, respectively. The nano-particles are also observed. The FTIR and EDS results show that the nano-particles are the products of incineration of plastics, including partly CH bond and unburned carbon, tar and ash.