阳极
材料科学
电解
电解质
极化(电化学)
浓差极化
多孔性
电解水
复合材料
分析化学(期刊)
膜
磁导率
电流(流体)
大规模运输
水运
电流密度
传质
电压
钛
化学工程
体积流量
聚合物
聚合物电容器
质子交换膜燃料电池
作者
Matthias Felix Ernst,Charlotte Schriever,Carina Schramm,Matthias Kornherr,J. Birkholz,Hubert Andreas Gasteiger
标识
DOI:10.1149/1945-7111/ae7193
摘要
In this work, three commercial, titanium fiber- or powder-based porous transport layers (PTLs) for polymer electrolyte membrane water electrolysis (PEMWE) are characterized in terms of pore size, porosity, surface roughness, and in-plane permeability. The latter is quantified using an in-house designed setup, revealing a nearly 10-fold higher permeability for fiber compared to powder-based PTLs. PEMWE polarization curves and high-frequency resistances are recorded with 5 cm 2 single-cells with serpentine flow fields (FFs), comparing the performance of the three anode PTLs in dependence of the anode FF land width (ranging from 0.7–6.2 mm; with a constant channel width and depth of 1 mm). A detailed voltage loss analysis reveals the absence of significant mass transport resistances at the anode side at low to moderate current densities, even when using the anode FF with the largest land width in combination with the PTL with the lowest permeability. In contrast, at high current densities (>2 A cm −2 ), the combination of large anode FF land width and low-permeability PTL leads to significant mass transport related performance losses, accompanied by a local dry-out of the membrane and a reduced MEA utilization, which can be rationalized by a simple model.
科研通智能强力驱动
Strongly Powered by AbleSci AI