The goals of this work were to synthesize high performance perovskite based thin film\nsolid oxide fuel cell (TF-SOFC) cathodes by pulsed laser deposition (PLD), to study the\nstructural, electrical and electrochemical properties of these cathodes and to establish\nstructure-property relations for these cathodes in order to further improve their properties\nand design new structures.\nNanostructured cathode thin films with vertically-aligned nanopores (VANP) were\nprocessed using PLD. These VANP structures enhance the oxygen-gas phase diffusivity,\nthus improve the overall TF-SOFC performance. La0.5Sr0.5CoO3 (LSCO) and\nLa0.4Sr0.6Co0.8Fe0.2O3 (LSCFO) were deposited on various substrates (YSZ, Si and\npressed Ce0.9Gd0.1O1.95 (CGO) disks). Microstructures and properties of the\nnanostructured cathodes were characterized by transmission electron microscope (TEM),\nhigh resolution TEM (HRTEM), scanning electron microscope (SEM) and\nelectrochemical impedance spectroscopy (EIS) measurements. A thin layer of vertically-aligned nanocomposite (VAN) structure was deposited in\nbetween the CGO electrolyte and the thin film LSCO cathode layer for TF-SOFCs. The\nVAN structure consists of the electrolyte and the cathode materials in the composition of\n(CGO) 0.5 (LSCO) 0.5. The self-assembled VAN nanostructures contain highly ordered\nalternating vertical columns formed through a one-step thin film deposition using a PLD\ntechnique. These VAN structures significantly increase the interface area between the\nelectrolyte and the cathode as well as the area of active triple phase boundary (TPB),\nthus improving the overall TF-SOFC performance at low temperatures, as low as 400oC,\ndemonstrated by EIS measurements. In addition, the binary VAN interlayer could act as\nthe transition layer that improves the adhesion and relieves the thermal stress and lattice\nstrain between the cathode and the electrolyte.\nThe microstructural properties and growth mechanisms of CGO thin film prepared by\nPLD technique were investigated. Thin film CGO electrolytes with different grain sizes\nand crystal structures were prepared on single crystal YSZ substrates under different\ndeposition conditions. The effect of the deposition conditions such as substrate\ntemperature and laser ablation energy on the microstructural properties of these films are\nexamined using XRD, TEM, SEM, and optical microscope. CGO thin film deposited\nabove 500 ºC starts to show epitaxial growth on YSZ substrates. The present study\nsuggests that substrate temperature significantly influences the microstructure of the\nfilms especially film grain size.