Application of Ionic Liquid Electrolyte to Lithium Ion Capacitor Based on Electrodes with Porous Three-Dimensional Current Collector

作者
Naoya Hirota,Kazuki Okuno,Masatoshi Majima,Satoshi Uchida,Masaki Yamagata,Masashi Ishikawa
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2016-02 (53): 4056-4056
标识
DOI:10.1149/ma2016-02/53/4056
摘要

A lithium ion capacitor (LIC) is a new storage device which combines an electric double-layer capacitor (EDLC) with a lithium ion battery (LIB). Namely, LIC consists of an activated carbon as positive electrode and lithium-ion-intercalating carbon material such as hard carbon as negative electrode. LIC also contains functionalities derived from both EDLC and LIB. During charge and discharge of LIC, ion adsorption/desorption occurs on the surface of the positive electrode, while lithium ion intercalation/de-intercalation occurs at the negative electrode. Although LIC features an excellent power density like EDLC, the energy density of LIC is lower than that of LIB. Therefore, improvement of energy density is required for LIC. In the present study, to achieve high energy density of LIC, porous 3-dimensinal (3D) current collector is applied to LIC electrodes. It is possible to increase the packing density of active material and make a LIC cell lighter. It is, however, expected that diffusion of carriers is limited with conventional organic electrolytes because electrodes using porous 3D current collector become massive; the typical thickness is ca. 1 mm. As a result, LIC using porous 3D current collector may deliver limited power. Thus, ionic liquids which have high carrier density would be useful as electrolyte of LIC to maintain power. The purpose of this study is applying an ionic liquid electrolyte to LICs with porous 3D current collector and investigating the basic operating characteristics. We assembled a three-electrode cell. A positive electrode using aluminum porous 3D current collector was made from activated carbon (AC, 87 wt.%), acetylene black (AB, 3 wt.%) and polyvinylidene di-fruoride (PVdF, 10 wt.%). A negative electrode using copper porous 3D current collector was made from hard carbon (HC, 87 wt.%), AB (8 wt.%) and PVdF (5 wt.%). A lithium foil was used as a counter electrode and reference electrode. The electrolyte was 1.5 mol dm−3 LiFSI/EMImFSI. The cell was galvanostatically charged and discharged for 3000 cycles at 1.0 C-rate in a voltage range of 2.0 – 3.8 V after a pre-doping process under predetermined conditions. We also evaluated rate performances of LIC cells with various electrolytes by rapid charging and discharging test. 1.5 mol dm−3 LiFSI/EMImFSI was used as standard ionic liquid electrolyte. 1.0 mol dm−3 LiPF6 / EC : DMC = 1 : 1 (v/v) and 1.0 mol dm−3 LiBF4 / EC : DMC = 1 : 1 (v/v) were used as organic electrolytes for comparison. C-rates for the power performance test were varied from 0.1 C to 30 C every 5 cycles after 100 pre-cycles. Fig. 1 shows potential profiles of positive and negative electrodes during charge and discharge at 2, 1000, 3000 cycles. It turns out that the LIC cell containing ionic liquid electrolytes is possible to charge and discharge reversibly as well as stably. Even though it was long-term cycling such as 3000 cycles, its capacity has not significantly decreased. Therefore, long-term cycle stability is high. Fig. 2 compares rete performances with the ionic liquid electrolyte and two organic electrolytes. Although ionic liquids have high viscosity [1], it is shown that FSI-based ionic liquid electrolyte has high rete performances comparable to a LiPF6-based organic electrolyte. This may be ascribed to high carrier density of ionic liquids. Rate performances of the FSI-based ionic liquid electrolyte and LiPF6-based organic electrolyte are superior to that of the LiBF4-based organic electrolyte. This is attributed to lower ionic conductivity of LiBF4. These results suggest that applying the ionic liquid electrolyte to a LIC electrode with porous 3D current collector is promising. FSI-based ionic liquid electrolytes may replace conventional organic electrolytes as electrolyte of LIC because of their resulting high cycle stability and high energy density without power loss. References [1] M. Ishikawa, T. Sugimoto, M. Kikuta, E. Ishiko, and M. Kono, J. Power Sources, 162, 658 (2006). Figure 1

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
刚刚
咕咕嘎嘎完成签到,获得积分10
1秒前
漫漫完成签到,获得积分10
1秒前
2秒前
2秒前
2秒前
2秒前
3秒前
3秒前
努力努力再努力y完成签到 ,获得积分10
3秒前
qq1083716237发布了新的文献求助30
6秒前
研友_8DoVVZ完成签到,获得积分10
6秒前
简单老师发布了新的文献求助30
7秒前
7秒前
科研通AI6.3的应助被yj采纳,获得10
7秒前
叉叉完成签到,获得积分10
8秒前
个人热滚滚完成签到,获得积分10
8秒前
liu发布了新的文献求助10
8秒前
仇湘发布了新的文献求助10
9秒前
9秒前
想喝奶茶完成签到,获得积分10
10秒前
李妍发布了新的文献求助30
10秒前
xxzzzx发布了新的文献求助10
10秒前
hz1207发布了新的文献求助10
11秒前
12秒前
12秒前
12秒前
tomatoli完成签到,获得积分10
13秒前
di完成签到,获得积分10
13秒前
13秒前
打打的应助被kgy采纳,获得10
14秒前
14秒前
勤劳的雨筠给勤劳的雨筠的求助进行了留言
14秒前
漫漫驳回了华仔的应助
14秒前
科研小白发布了新的文献求助10
14秒前
科研通AI6.2的应助被Xu采纳,获得10
15秒前
15秒前
伍陆伍陆两完成签到,获得积分10
16秒前
zzzz发布了新的文献求助10
16秒前
16秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
Boundaries and Bodhisattvas 500
高分子基功能界面水蒸发材料与应用研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8181888
求助须知:如何正确求助?哪些是违规求助? 9571628
关于积分的说明 21818887
捐赠科研通 7778145
什么是DOI,文献DOI怎么找? 3433528
关于科研通互助平台的介绍 2557710
邀请新用户注册赠送积分活动 2479621