材料科学
兴奋剂
光电子学
噪音(视频)
质量(理念)
遥感
固态
电气工程
计算机科学
领域(数学)
作者
Karisse A. Hikaru Chandra Yamamoto,Fariborz Taghipour
标识
DOI:10.1016/j.sbsr.2026.101022
摘要
Nitrous oxide (N 2 O) is widely used as an anesthetic gas, posing safety risks for medical professionals. It is also a potent greenhouse gas present in various agricultural settings and impacting environmental health. Current N₂O detection technologies are limited by their bulkiness, high cost, and unsuitability for real-time, on-site monitoring. This study presents a novel approach for developing a chemiresistive sensor, built on a low-power, miniaturized platform that can detect N 2 O gas at room temperature using UV activation. The N 2 O sensing material was developed by synthesizing Sr doped SnO 2 through co-precipitation, and it was activated by UV radiation. The sensor measured concentrations of N 2 O ranging from 30 to 100 ppm, a critical range for workplace safety. The composition of the sensing layer was investigated, revealing that optimal gas-sensing performance occurred at 3 wt% Sr doping. The introduction of Sr into the SnO 2 lattice was found to (i) inhibit crystallite growth, thus increasing surface area coverage and (ii) create oxygen vacancies, thereby reducing charge carrier recombination and enhancing sensor response. The sensor responded to N₂O and then recovered to its baseline resistance in approximately 130 s and 150 s, respectively, making it suitable for real-time detection and the provision of timely hazard alerts for workers. A key advantage in using a UV-LED energy source is the potential for adjusting its operational parameters (irradiance and wavelength) to enhance gas-sensing performance. The choice of wavelength was found to influence sensor reproducibility and stability under N₂O exposure by varying the photonic energy. The optimal low irradiance condition of 11 μW/cm 2 demonstrated high response, highlighting the low power consumption of UV-activated sensors.
科研通智能强力驱动
Strongly Powered by AbleSci AI