Analysis of the Possibilities of Improving the Selected Properties Surface Layer of Butt Joints Made Using the FSW Method

The paper presents the results pertaining to an analysis on the influence of technological parameters of pneumatic shot peening technology on the selected properties of a surface layer of butt joints made with Friction stir welding (FSW) method.Butt joints made of two 2024-T3 aluminum alloy sheets with the thickness of 1 mm were shot peened with glass beads.The experiments were carried out according to the statistical 3-level completed plan PS/DC 3 2 .The technological parameters were changed in the range: pressure p = 0.4-0.6MPa and peening time t = 1-3 min.As a result of the conducted research, adequate equations describing the effect of the analyzed parameters on the surface roughness were obtained.Shot peening with glass beads significantly reduced the surface roughness from Ra = 5.2 µm to Ra = 1.42 µm.This treatment provides high compressive residual stresses and the increase of the surface layer hardness.The results show that shot peening is a highly efficient and cost-effective mechanical treatment used for improving the mechanical properties of the butt joints made with the FSW method.